manual-laser-cpsport-cp99, ENCYKLOPEDIE, Techniki, Dokumenty

[ Pobierz całość w formacie PDF ]
Laser
CP99 / CPSport Laser Sight
OPERATION INSTRUCTIONS
D A N G E R
LASER RADIATION–AVOID
DIRECT EYE EXPOSURE
LASER DIODE
Wavelength 635-655 nm
Output Power <5mW
CLASS IIIA
LASER
PRODUCT
CAUTION: Your airgun is not a toy. Treat it with the same
respect you would a irearm. Always read all operation
instructions found here and in your airgun’s owner’s manual.
If you do not have instructions or an owner’s manual, contact
Umarex USA or visit www.UmarexUSA.com.
LASER SIGHTS ARE NOT TOYS. LASERS
MUST BE USED UNDER THE SUPERVISION
OF AN ADULT. IMPROPER USE OR CARELESS USE MAY CAUSE
SERIOUS INJURY, ESPECIALLY TO THE EYES. AVOID DIRECT
EXPOSURE TO THE LASER BEAM. AVOID SHINING AT MIRRORS.
DO NOT AIM AT ANY PERSON OR ANIMAL’S EYES.
KEEP OUT OF REACH OF CHILDREN.
HOW TO MOUNT YOUR CP99 / CPSPORT
LASER SIGHT
CAUTION: In order to avoid injury, keep the laser off until
you are ready to aim and shoot. Make sure the laser is off when
you mount or remove the laser sight.
Mount the laser sight as shown
in the illustration (See Fig. A).
Mount with the laser beam
aperture to the front and push
carefully back onto mounting
rail, until the laser sight locks
in place.
Fig. A
HOW TO REMOVE YOUR CP99 / CPSPORT
LASER SIGHT
To remove the laser sight,
press the locking lever down
on both sides at the same time
and remove the sight from the
mounting rail
(See Fig. B).
Fig. B
Locking lever
HOW TO OPERATE YOUR LASER SIGHT
CAUTION: Make sure the air pistol is pointed in a
SAFE DIRECTION. Keep the laser off except when shooting.
Never look directly at the laser or point the laser at anything
you do not intend to shoot.
Turn the laser on and aim.
Switch in the upper position = OFF
Switch in the lower position = ON
Fig. C
Switch
Continued on reverse.
WARNING:
HOW TO AIM AND ADJUST YOUR
LASER SIGHT
Use the front and rear sight to aim the
airgun. The laser dot should appear to
sit on top of the front sight (See Fig. D).
If this is not the case, make the following
adjustments by using a hex key:
Windage adjustment
If your airgun shoots too far right,
turn the windage adjustment
screw counter-clockwise. If your
airgun shoots too far left, turn
the windage adjustment screw
clockwise (See Fig. E).
Elevation adjustment
If your airgun shoots too low, turn the elevation adjustment screw
counter-clockwise. If your airgun shoots too high, turn the elevation
adjustment screw clockwise (See Fig. E).
Laser dot
Rear sight
blade
Fig. D
Front sight
Windage
adjustment
screw
Fig. E
Elevation
adjustment
screw
HOW TO INSTALL OR CHANGE THE BATTERIES
This laser sight utilizes two(2) round cell silver oxide batteries—
SR44 or SR44W. Two batteries were included in the original laser
sight packaging.
1. To access battery compartment,
press in latch and lift up on
compartment door and slide to
front of laser (See Fig. F).
2. Remove old batteries if present
and insert new batteries keeping
in mind their polarities (See Fig. G).
3. Close battery compartment by
replacing compartment door.
Battery compartment
Latch
Fig. F
Fig. G
CAUTION: Buyer and user have the duty to obey all laws
governing the use and ownership of airguns and laser sights.
Technical Data
Laser Class III. Maximum output < 5mW
Wavelength 635-655 nm
Batteries Two(2) round cell silver oxide SR44 or SR44W
Ø11.6 x 5.4 / 1.55v
Mounting Snap connection on Weaver rail
Special Feature Two(2) LED indicators on the rear side
Weight / Size
6007 South 29th Street
Fort Smith, Arkansas 72908 USA
Phone: 479-646-4210
www.UmarexUSA.com
50 g / 60 x 42 x 26 mm
[ Pobierz całość w formacie PDF ]

  • zanotowane.pl
  • doc.pisz.pl
  • pdf.pisz.pl
  • mement.xlx.pl

    • Tematy